Madnarski Sutikno, Uda Hashim, Zul Azhar Zahid Jamal
In essence, quantum dot dimensions and others can be laterally and vertically defined by using either bottom up or top down methods respectively. In fabrication that uses top down method, etch process hold a chief role. Varieties of etch times and oxygen flow rates in ranges 75-88 s and 20-50 sccm, respectively, were devised to fabricate optimum dimension of nanostructure. As a result, as etch time increased, lateral etch rate of silicon quantum dot, source and drain and also the nanostructure etch depth increased. However, high roughness of etched silicon surface profile led to concave surfaces of source and drain. In this research, no significant relation between quantum dot diameters and oxygen flow rates was found. There was a reflection point, fixed data dot of 26 sccm, of the decreasing and increasing lines of relation between nanostructure depth of etched silicon and nanostructure gradient with the O2 flow rate. © 2007 Elsevier Ltd. All rights reserved.
Physics Department, Faculty of Mathematics and Natural Sciences, Universitas Negeri Semarang (UNNES), Gunungpati, Semarang 50229, Indonesia; Nano Fabrication Cleanroom, School of Microelectronic Engineering, Universiti Malaysia Perlis (UniMAP), Kuala, Perlis, 02000, Malaysia
Research at a Glance
Register to unlock
Topics & SDG Alignment
Register to unlock
Collaboration
Register to unlock
Author Profile (Selected)
Register to unlock
References Overview
Register to unlock
Journal & Source
Register to unlock
Metadata & Integrity
Register to unlock